IMPLEMENTASI PENGGUNAAN HI-GRID FRP MOLDED GRATING

Hengshui Jrain, completed a lot of FRP fittings for our Australia customer, and they were loaded from workshop today. Hope their travel oversea is joyful.

For this project, Jrain, with its good staff including sales, engineering, production, logistics and so on, did the engineering, fabrication, pre-assembly, packing and all necessary works from the beginingg to the end, and the finished launders got the appreciation from the end customer.

The polymerization of resin monomers was initiated in the presence of nanofibers as structural templates to prepare a hydrogel with nanofibrous networks, followed by the drying and pyrolysis to get hard carbon aerogel. During polymerization, the monomers deposit on templates and weld the fiber-fiber joints, leaving a random network structure with massive robust joints. Moreover, physical properties (such as diameters of nanofiber, densities of aerogels, and mechanical properties) can be controlled by simply tuning templates and the amount of raw materials.

Due to the hard carbon nanofibers and abundant welded joints among the nanofibers, the hard carbon aerogels display robust and stable mechanical performances, including super-elasticity, high strength, extremely fast recovery speed (860 mm s-1) and low energy loss coefficient (<0.16). After tested under 50 % strain for 104 cycles, the carbon aerogel shows only 2 % plastic deformation, and retained 93 % original stress.

Common sheet sizes for FRP grating include: 4’x8′, 4’x12′, and 3’x10′. Common thicknesses include: 1″, 1.5″ and 2″

Fiberglass FRP

In stock at a distribution center close to you.