we carry a wide range of FRP products and systems designed to give you maximum choice. In the case of our reinforced grating, we offer two major product lines: molded grating and pultruded grating. Each manufacturing method has its own advantages and results in products with their own mix of performance and durability advantages. If you’re hesitating between molded versus pultruded grating, our experienced team can help you make that decision by highlighting the benefits of each.
insert rock bits. Engineers use advanced software to map out the drilling path, ensuring the bits are aligned optimally for maximum effectiveness. This not only enhances drilling speed but also reduces wear and tear, extending the lifespan of the bits.You can use fiberglass grating in a variety of construction sites. It is easy to transport and can be cut on-site to fit whatever purpose it’s intended for.
pultruded fiberglass grating. It can be cut to size on site without the need for special tools, and its non-corrosive properties mean it requires minimal maintenance over its long lifespan.
1, the blade barbed rope damage should be timely corrected
The technical term “galvanized” means that metal has been specially treated with zinc. Essentially, the wire is covered with a very thin layer of zinc. It is this thin layer of zinc that gives galvanized wire its many properties. Galvanizing can be done by dipping wire into a pool of zinc or by electroplating. Are you familiar with galvanized wire mesh? Do you know what to pay attention to in the process of use?
The use of packaging galvanized wire with the development of industry and agriculture is also expanded accordingly. Therefore, galvanized silk commodities have been widely used in industry (such as chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding, etc.), agriculture (such as irrigation, heating houses), construction (such as water and gas transportation, wire casing, scaffolding, houses, etc.), Bridges, transportation, etc., in recent years. Because galvanized silk products have beautiful surface, good corrosion resistance and other characteristics, its use is more and more extensive.
The production process of stainless steel blade and galvanized blade is basically similar. The blade size is usually determined according to the mold.
The material of small hexagonal mesh is the same as that of other hexagonal mesh, which is generally made of low carbon steel wire, stainless steel wire and galvanized steel wire as raw materials by the hexagonal mesh machine.
1. After getting the bird cage, do not rush to use it. Clean the cage with a clean cloth or rubber. Then use fine yarn paper (do not use coarse sandpaper randomly), gently polish some parts that need to be polished again to improve the surface finish and trace, and pay attention to not damage the original bamboo green. After careful observation, use a razor blade to carefully clean the individual areas with small burrs.
In order to remove defects such as surface film layer and surface inclusion of large roll galvanized wire, it can be treated by conventional technology. The presence of small homogeneous particles of large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles can cause explosion. Activated carbon mat to remove surface active substances, or through filtration to make the foam less stable, these are effective measures; Other measures should also be taken to minimize the intake of surface active substances. The electroplating speed can be significantly reduced by the introduction of organic matter.
In the use of time do not need to carry out daily maintenance and maintenance, not only can save a lot of time, but also can reduce the cost, but also has good stability, strong corrosion resistance, greatly prolong the service life. According to the different process is divided into different kinds, can be selected according to their own needs, has good flexibility and elasticity. The main role of annealing wire is to control its degree of hardness and softness. When making annealing wire, it is made of steel wire.
The temperature of large roll galvanized wire should be controlled at 30 to 50℃ during electroplating. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used. Continuous production does not need heating, but needs cooling. Cooling can be in the groove side row thin wall plastic pipe, through the flow of tap water cooling, can also be used as a titanium pipe temperature control device.
