large diameter fiberglass pipe

2. Eliminate caked zinc residue on zinc liquid surface
Each coil of steel wire shall consist of one wire. The surface of the rod shall not have cracks, folds, scars, ears, layers or inclusions. However, indentation, pits, bumps, scratches and pockmarks are allowed, and the depth or height shall not be 0.2mm. There should be no corrosion and oxidation skin on the surface of the steel wire, and oxidation color is allowed by heat treatment. The surface of the wire is allowed to have scratches not exceeding half of the allowable deviation range of the diameter, and local defects not exceeding the allowable deviation of the appropriate diameter.
Hot dip galvanized wire is dipped in zinc liquid melted by heating, with fast production speed and thick but uneven coating. The market allows a low thickness of 45 microns and a high of more than 300 microns. The color is dark, the consumption of zinc metal is much, and the matrix metal forms the infiltration layer, the corrosion resistance is good, the outdoor environment of hot dip galvanized wire can be maintained for decades.
Paint on the galvanized layer, the bonding force between each other has a great relationship with the baking temperature of the paint, and alkyd paint is coated after galvanized, and the adhesion is not a problem. After galvanized to do amino paint, paint adhesion is not very good. Do two bottom two surface, adhesion is good, if the two bottom two surface changed to two bottom three surface, that is, more paint, more baked once, again test adhesion is very bad, bad enough to tear the paint from the galvanized layer.
Post time: 08-09-22
Choose a cage that can stand up straight in order to keep your dog comfortable. Lay down with your feet out wide. The dog, can save much, can buy a small cage, can also see it as the same as people, give it a bigger cage, so that it can use half to activity, half to sleep. Use an old blanket for your dog’s crate, or buy a pet mat, as long as it’s comfortable.
Cold galvanized is in the plating tank through the current unidirectional zinc gradually plated on the metal surface, production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust. Compared with electrogalvanizing, hot galvanizing has lower production cost and less impact on the environment than electroplating.
Post time: 31-08-22
1. Choose according to your dog’s size
2, galvanized wire mesh molding sheet storage ground should be flat, according to the symbolic requirements of the accumulation of regular, height should not exceed 2M, and away from heat sources, avoid exposure.
(6) Save transportation costs. It can be reduced into small rolls, and involved in moisture-proof paper packaging, occupying little space.
Decorative hook mesh selection of stainless steel, aluminum alloy, brass, copper and other alloy materials, through the special process of preparation of hook mesh. It is a silk screen made of decoration. Today we introduce the aperture and wire diameter of the decorative hook mesh.
Uses: water conservancy engineering, river regulation engineering, dike engineering, ecological protection engineering, channel lining, road engineering, river bank reinforcement, ocean engineering, landscape design engineering, bridge reinforcement, railway and highway slope protection, retaining wall, ecological river bank slope regulation and other engineering.
Post time: 27-05-22
Dip plastic hook net disposal characteristics and downwind, dip plastic is also a common comparison, surface treatment color comparison is single, generally dark green, however, if you want to change into other colors, dip plastic will be more convenient. Because its inner line or inner tube is generally iron line, so, after a period of time, the inner line or inner tube will slowly corrode outward, compared to the outside of the glue fade, hook net will die.
Post time: 23-08-22
Therefore, when zinc reaches saturation in the solid melt, the two elements of zinc and iron atoms diffuse with each other, and the zinc atoms diffused into (or infiltrated into) the iron matrix migrate in the lattice of the matrix and gradually form an alloy with iron, while the iron diffused into the molten zinc liquid forms an intermetallic compound FeZn13 with zinc and sinks into the bottom of the hot-dip galvanized pot, that is, zinc slag. When the workpiece is removed from the zinc leaching solution, the surface of the pure zinc layer is formed, which is hexagonal crystal, and its iron content is not more than 0.003%.
Post time: 12-04-23
Common galvanized iron wire equipment is usually used in the barbecue net, barbecue net generally requires to have a long service life, with galvanized iron wire equipment to the wire on a layer of zinc, barbecue net is not easy to be corroded.
If the connection near the installation is not completely aligned, then the installation has been aligned, and then the rest of the attachment installation, it will be relatively simple, and then install the blade thorn rope, installation of blade thorn rope must be the blade thorn rope with a clip card below the guardrail. And this will not damage the purse Seine, after the installation of the accessories, the guardrail is also equal to the installation, and then check the fixing of the screws, to determine that there is no problem after.
Post time: 17-11-22
Post time: 09-03-23
For single-layer wound non-rotating wire rope, it is necessary to strictly abide by the above principles, otherwise it is easy to cause permanent deformation of wire rope structure; In the case of multilayer winding, the rotation of the rope is determined by the orientation of the reel’s rope groove to lay the foundation for the next layer. The friction between the wire rope and the extrusion pressure of the multi-layer winding drum are large, and the disorderly rope phenomenon is easy to occur. Therefore, the wire rope with a diameter slightly smaller than the pitch of the rope groove and the diameter of the rope groove should be selected to add the touch area between the wire rope and the drum.
The blade thorn rope is formed by the punching steel plate and mechanically rolled on the steel wire. The width of the blade is 22mm, the vertical distance between the two blades is 15mm, the longitudinal distance between the blade is 34mm, and the diameter of the core wire is 2.5mm. The blade is made of Q195 steel plate with 0.5mm thickness.
Post time: 22-02-23
Cattle net in the outdoor use of a long time will inevitably show rust corrosion, this time the use of cattle net life depends on the maintenance of the product is not in place, we all know that cattle net if long exposure to harsh environment, the service life will be greatly reduced. How long does a normal cattle net last?
(4) granary storage, circle corn net.
The material of the electric welding net is black wire, galvanized wire and wire drawing. The mesh is 1 inch, 2/1 inch, 3/1 inch, 4/1 inch, 4/3 inch, 8/5 inch, etc. Different materials, different mesh, used in different places. Therefore, electric welding net is an indispensable building material in the construction industry.
The silver powder is actually a mixture of aluminum powder and polymer after painting the film, the film is brittle, easy to appear adhesion problems, and corrosion resistance is also slightly poor. Galvanizing refers to the surface of metal, alloy or other materials coated with a layer of zinc to play the role of beautiful, rust prevention and other surface treatment technology. Zinc dissolves easily in acids and also in bases, so it’s an amphoteric metal. Zinc changes little in dry air.
5, after the light plating should be carried out light treatment.
1, galvanized wire mesh molding sheet must be packed with flat hard data, to avoid eternal deformation due to poor packaging. It IS VERY IMPORTANT THAT EACH PACKAGE AND ROLL OF RAW SHEET MATERIAL BE MARKED WITH PRODUCT NAME, STANDARD, QUANTITY, TRADEMARK, batch number, MANUFACTURER, DATE of production, STACKING SYMBOL, INSPECTOR CODE AND INSPECTION CERTIFICATE.