Some dealers quoted prices that were significantly higher than expected, sending the domestic market to an almost three-year high. Meanwhile, a similar scenario was observed in the Indian market, where titanium dioxide prices (rutile grade) for rose by 8% from January to March. The increase was attributed to strong demand from the domestic paints and coatings sector as well as premium cargo from China.

≤0.3

Titanium dioxide is a mineral that’s used as a white coloring in a variety of products, including sunscreens, cosmetics, paints, and plastics. The pigment grade is also known as titanium white, pigment white 6, or CI 77891; it's the whitest and brightest of all known pigments.

Although the evidence for general toxic effects was not conclusive, on the basis of the new data and strengthened methods we could not rule out a concern for genotoxicity and consequently we could not establish a safe level for daily intake of the food additive, commented Matthew Wright, member of the EFSA's Food Additives and Flavourings Panel in a press statement.

Above 20%, it is recommended to replace 1 kg TiO2 with 1.3 kg of lithopone supplier 30%.  

if you compare the levels—which went as high as 50,000 milligrams/killigrams per day— to what humans are actually exposed to, we're talking orders of magnitude. It was a huge amount, Norbert Kaminski, PhD, a professor of pharmacology & toxicology and director of the Center for Research on Ingredient Safety at Michigan State University told Health.

Testing samples were made mixing 100 uL of TiO₂NPs suspensions (0.2 mg/mL and 0.02 mg/mL) and vitamins@P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL) with 100 μL ATCC 29,213 methicillin-sensitive Staphylococcus aureus (MSSA) (10⁷ in PBS, pH 7). Controls were made replacing nanoparticles with the same volume of PBS. The concentrations of nanoparticle suspensions were chosen based on the FDA approved maximal and the minimal amount usually found in sunscreens, which are 20% and 2% (this is equivalent to 0.2 mg/mL and 0.02 mg/mL for nanoparticles suspensions). The cream concentration, on the other hand, was an intermediate value of 10%.

To overcome this challenge, manufacturers use advanced technology and processes to monitor and control the buff percentage of their products. This may involve the use of sophisticated equipment to measure the coating thickness of titanium dioxide particles, as well as automated systems to adjust the level of coating as needed. By carefully controlling the buff percentage, manufacturers can ensure that their products meet the specifications of their customers and maintain a high level of quality and performance.