Titanium dioxide nanoparticles may accumulate and cause DNA damage

The FDA is reviewing the safety of titanium dioxide in response to an April petition from EWG and other environmental and public health groups. This is the FDA’s first comprehensive review of titanium dioxide since 1973.

Blanc de lithopone, blanc de Comines, zincolith, blanc de Charlton, blanc de Becton, tithopone

Although barium sulfate is almost completely inert, zinc sulfide degrades upon exposure to UV light, leading to darkening of the pigment. The severity of this UV reaction is dependent on a combination of two factors; how much zinc sulfide makes up the pigments formulation, and its total accumulated UV exposure. Depending on these factors the pigment itself can vary in shade over time, ranging from pure white all the way to grey or even black. To suppress this effect, a dopant may be used, such as a small amount of cobalt salts, which would be added to the formulation. This process creates cobalt-doped zinc sulfide. The cobalt salts help to stabilize zinc sulfide so it will not have as severe a reaction to UV exposure.

We know that there are a lot of suspended organisms and colloidal impurities in natural water. The forms of suspended solids are different. Some large particles of suspended solids can settle under their own gravity. The other is colloidal particles, which is an important reason for the turbidity of water. Colloidal particles can not be removed by natural settlement, because colloidal particles in water are mainly clay with negative electricity The Brownian motion of colloidal particles and the hydration on the surface of colloidal particles make colloidal particles have dispersion stability. Among them, electrostatic repulsion has the greatest influence. If coagulant is added to water, it can provide a large number of positive ions and accelerate the coagulation and precipitation of colloid. Compressing the diffusion layer of micelles makes the potential change into an unstable factor, which is also conducive to the adsorption and condensation of micelles. The water molecules in the hydrated film have fixed contact with the colloidal particles and have high elastic viscosity. It is necessary to overcome the special resistance to expel these water molecules. This resistance hinders the direct contact of the colloidal particles. The existence of some hydrated films depends on the electric double layer state. If coagulant is added to reduce the zeta potential, the hydration may be weakened. The polymer materials formed after coagulant hydrolysis (the polymer materials directly added into water generally have chain structure) play an adsorption bridging role between the colloidal particles. Even if the zeta potential does not decrease or does not decrease much, the colloidal particles can not contact each other and can be adsorbed through the polymer chain Colloidal particles can also form flocs.

The biological activity, biocompatibility, and corrosion resistance of implants depend primarily on titanium dioxide (TiO₂) film on biomedical titanium alloy (Ti6Al4V). This research is aimed at getting an ideal temperature range for forming a dense titanium dioxide (TiO₂) film during titanium alloy cutting. This article is based on Gibbs free energy, entropy changes, and oxygen partial pressure equations to perform thermodynamic calculations on the oxidation reaction of titanium alloys, studies the oxidation reaction history of titanium alloys, and analyzes the formation conditions of titanium dioxide. The heat oxidation experiment was carried out. The chemical composition was analyzed with an energy dispersive spectrometer (EDS). The results revealed that titanium dioxide (TiO₂) is the main reaction product on the surface below 900°C. Excellent porous oxidation films can be obtained between 670°C and 750°C, which is helpful to improve the bioactivity and osseointegration of implants.

We’re most often exposed to E171 through the foods we ingest. We find E171 in many food products, like popsicles, ice cream, gum, and more. Another way we ingest E171 is through pharmaceutical drugs. Many pills and capsules contain E171 as an inactive ingredient.  

The US and Canada, however, approve the use of titanium dioxide as a food additive. Canada's recent review of titanium dioxide reconfirmed its safety and pointed out that many of the toxicity studies the EU reviewed were not relevant to the safety of titanium dioxide as a food ingredient, and that the ban is based on an abundance of caution and uncertainty.

In a study published in 2022 in the journal Particle and Fibre Technology, researchers examined the impact of maternal exposure to titanium dioxide nanoparticles in newborn offspring mice. They found that “a chronic exposure to TiO2 NPs during pregnancy alters the respiratory activity of offspring, characterized by an abnormally elevated rate of breathing.” Breathing was also shown to be “significantly and abnormally accelerated,” and the ability for neural circuitry to effectively adjust breathing rates was impaired. The researchers concluded: “Our findings thus demonstrate that a maternal exposure to TiO2 NPs during pregnancy affects the normal development and operation of the respiratory centers in progeny.”