The spark plug is essentially a device that generates an electric spark to ignite the compressed air-fuel mixture inside the engine cylinder. This ignition process creates a small explosion, which pushes the piston down and ultimately drives the vehicle forward. Without spark plugs, the engine would not be able to start or run efficiently.

In situations where the shaft has splines or an integral gear on the end, you’ll want to take precautions. These gears and splines often have very sharp edges that are quite detrimental to the seal’s integrity. You may use an installation sleeve that will allow the seal to slide past these hazards undamaged.

The simplest way is to know either the preferred manufacturers part number, the overall sizes of shaft diameter, housing diameter and bore depth.Many of the old traditional names of seal manufacturers have either changed or disappeared in this age of “acquisitions”. If no longer available, we will advise you and offer a suitable alternative seal, from stock whenever possible. If your concern is getting the right seals for the job, you will need to know something about the application as well as the overall sizes. If you have any doubts – contact us, we will help in your seal selection.

Modern engine oils, such as the current SG classification for gasoline engines, contain a large fraction of additives, many of which are detrimental to fluoroelastomers. The primary functions of oil-additive packages are to protect metal parts, avoid deposits in the engine, minimize oil degradation, and adjust fluid viscosity. Little attention has been paid to avoiding damage to rubber seals. Instead, elastomer producers have been expected to provide new, higher-performing products at no increased cost to auto manufacturers. Among the additives with moieties that may attack fluoroelastomers at high temperature are detergents (phenolates), dispersants (succinimides, alkylphenol amines), and antioxidants (amines, sulfides, hindered phenols).⁴ Many of these components are multifunctional, containing phenol or amine groups that can dehydrofluorinate and crosslink VDF-containing fluoroelastomers, leading to loss of elongation and eventual embrittlement. However, the rate and extent of reactions with seals are affected by many factors, including whether air is present in the system. When oil is exposed to air at high temperature, additives may undergo considerable changes. For example, a significant fraction of amines may be oxidized to amides, which have little effect on fluoroelastomers.⁵