Bit drilling is also known for its precision and accuracy
- No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.
- (7) twist twist hexagonal mesh is made to use low carbon steel wire galvanized large wire braided, the tensile strength of steel wire is not less than 38kg/㎡, the diameter of steel wire up to 2.0mm-3.2mm, the surface of steel wire is usually hot galvanized protection, galvanized protective layer thickness can be made according to customer requirements, galvanized amount can reach 300g/㎡.
- Because of the pre-tension given to the packaging and binding of galvanized wire, it has the excellent characteristics of low relaxation value, small stress loss, good stability after loading, not easy to deformation, no fracture, strong elasticity, ordinary steel lines and rebar are difficult to compare. The use of advanced galvanized finishing process, therefore, the use of hot-dip galvanized steel wire construction, not only good corrosion resistance, but also beautiful and generous. The product has the characteristics of smooth surface, high dimensional accuracy, good uniformity of zinc layer and strong adhesion.
3, a wide variety of specifications, a variety of shapes you choose, both European and American style and today’s popular fashion, full noble and modern beauty.
- Performance characteristics of zinc coating: zinc layer of thick galvanized wire zinc layer crystallinity meticulous, uniform and no gap, good corrosion resistance; The zinc layer obtained by electrogalvanizing is very pure and corrodes slowly in the gas, liquid and fog of acid and alkali, which can effectively protect the steel matrix. Galvanized layer can also be chromic acid passivation treatment into a variety of colors, beautiful and generous, with good decorative; The zinc layer on the galvanized wire has good ductility, can be cold blanking, rolling, bending and other molding without damage to the zinc layer.
Post time: 08-05-23
Post time: 29-07-22Paint on the galvanized layer, the bonding force between each other has a great relationship with the baking temperature of the paint, and alkyd paint is coated after galvanized, and the adhesion is not a problem. After galvanized to do amino paint, paint adhesion is not very good. Do two bottom two surface, adhesion is good, if the two bottom two surface changed to two bottom three surface, that is, more paint, more baked once, again test adhesion is very bad, bad enough to tear the paint from the galvanized layer.
- 2, see if solder joint is firm, net width on both sides of whether level off, the wire have broken wire phenomena (note: net length is the length of the wire), welded wire mesh of the solder joint is normal after precise voltage debugging, welding of welded wire mesh with graphite, strong, and the net width on both sides of the cutting time is according to the broken wire knife to ensure smooth on both sides, There will be no leakage cutting on both sides of the protrusion of the wire is not cut off the phenomenon, the wire is broken, because the wire is not used up even if the column hole is blocked by the wire can not enter the normal cause, such as broken phenomenon can appear on the surface of the electric welding network lack of a wire.
There is good toughness and elasticity, simply put, can be easily made into various shapes, and zinc as a coating is silver, very beautiful. Such characteristics make hot dip galvanized wire handicrafts, woven screen and other aspects have also been applied. Hot plating wire selection of high quality low carbon steel rod processing, is the selection of high quality low carbon steel, after drawing molding, pickling rust removal, high temperature annealing, cooling and other processes.
Widely used in practice, iron wire also has certain harm, simple rust and corrosion, so we can generally use galvanized method to prevent product corrosion. Together in addition to this method, metal commonly used treatment methods and phosphating treatment, oxidation treatment, etc. Metal phosphating treatment: iron and steel products to remove oil, rust, into the specific composition of the salt solution soak, you can form a layer of water soluble salt film on the surface of the metal, this process is called phosphating treatment.
The impregnated hexagonal wire mesh will lose its original characteristics after corrosion, and will change in shape, color and mechanical properties, resulting in equipment damage, pipeline leakage, etc., specifically, it is easy to break and lose the original protection function. Usually there are three kinds of metal corrosion: physical corrosion, chemical corrosion, electrochemical corrosion, corrosion in addition to the chemical properties and organizational structure of the metal itself, but also related to the surrounding medium, such as wet environment than dry environment easy corrosion, more impurities than impurities less easy corrosion, high temperature conditions than low temperature conditions easy corrosion. After understanding these, we can effectively prevent the corrosion of impregnated hexagonal wire mesh, prolong the service life of products.
Galvanized wire A stable layer of zinc is coated on the outside of the wire, which is used to protect the wire and make the wire service life longer. When producing galvanized wire, the wire is pickled. Pickling is to use some acid mist or acid to wash off some oxides on the surface of iron, that is, rust, and some other corrosive substances, to achieve the purpose of cleaning iron, so that zinc will fall off when galvanizing.
In order to orchard special electric galvanized shaft wire in alluvial surface to partially remove the surface film layer, surface impurity and other shortcomings can be found and solved according to the basic technology; Excessive foam is caused by soap and soapable surface active substances such as human fat into the tank. A moderate rate of foam production would be fine. The large amount of fine homogeneous particles in the tank can stabilize the foam layer, but the accumulation of too much solid particles will cause explosion.
Hot dip galvanizing is also called hot dip zinc and hot dip galvanizing: is an effective way of metal corrosion, mainly used in various industries of metal structure facilities. It is to immerse the steel parts after rust removal into the molten zinc liquid at about 500℃, so that the surface of the steel parts is attached with zinc layer, so as to play the purpose of anticorrosion. Hot dip galvanizing process: finished product pickling – washing – adding bath aid – drying – hanging plating – cooling – drug – cleaning – grinding – hot dip galvanizing completion. Hot dip galvanizing is developed from the older method of hot dip galvanizing. It has a history of 140 years since it was applied to industry in France in 1836. However, the hot dip galvanizing industry has been developed on a large scale in the past 30 years with the rapid development of hot dip galvanizing wire.
- 2. Breeding small animals such as chickens, ducks and geese, enclosure protection for fruit trees and gardens, and protection for medium-sized breeding, it is recommended that you choose products with a wire diameter of 2.3mm-2.5mm.
The construction of inner wall and outer wall steel wire mesh can effectively solve the wall cracks, falling off, empty drum phenomenon. Hot dip galvanized steel wire mesh material requirements: net surface leveling, width and length to meet the project required standards, welding process, weight, zinc, etc., with more production and operation, detection certificate is complete.
Hexagonal mesh is based on wire mesh prepared by metal wire, wire diameter of 0.3-2.0mm metal wire. Hexagonal mesh is a good choice for breeding cage, he is through hot dip galvanized or PVC coated plastic disposal, the structure is tightly combined with no bump and convex appearance. Keep chickens and ducks, isolate chicken and duck houses, and try to take care of poultry.
Stainless steel hexagonal network is composed of machine will be produced stainless steel wire of a kind of metal mesh, not easy corrosion, the survival of the fixed number of year is longer, net of wide, coarser size, strong practicability, flexibility and other unique places, stainless steel hexagonal wire netting material is stainless steel wire, wire diameter because stainless steel wire big viscosity of large stainless steel hexagonal network would be hard to manufacture, Of course, it is more difficult to hold the edge or twist the edge, so stainless steel hexagonal mesh whether from the material or artificial are expensive, but stainless steel hexagonal mesh will not rust and use years is also very long, appearance without disposal can achieve the use effect.
Post time: 09-09-22Stainless steel barbed wire in the way of corrosion is not too, because the surface is not treated but relies on its own raw materials for corrosion resistance, so there will be no chemical reaction.
Post time: 30-05-22- 5. It prevents your dog’s fear from causing chaos or other problems.
The spray blade has strong adhesion and mechanical strength, and is widely used in the isolation and protection of the boundary of grassland and railway, as well as the protection of garden apartments, units and prisons. The following Haorong for you to introduce the characteristics of spray blade rope.
Post time: 28-06-22The purchase of blade barbed rope also needs to consider the higher manual installation cost in the later period. Generally, customers only ask the price of blade barbed rope, and sometimes the installation cost is not taken into account in the budget, which is very unreasonable. Because the installation cost is not cheaper than the rope itself, sometimes even the blade rope and column combined. The blade stabbing rope needs a lot of manpower and material resources for installation. In general, the installation cost is also a relatively large expenditure item in the stabbing rope project.
- The advantage of the steel mesh sheet is that the steel mesh sheet ensures the quality of the project and is made by the automatic and intelligent production line under the strict quality control of the factory. The mesh size, steel bar specifications and quality of the steel mesh are strictly controlled. Avoid artificial mesh leakage, bonding is not strong, bonding error and Jerry construction. The mesh steel has large rigidity, outstanding elasticity, uniform, accurate spacing and high welding point strength. Thus greatly improve the quality of the project.
- Slowly through the axial flow fan or exhaust hole directly discharged to the sand blasting room, so that the power of dust discharge is low. And in the discharge of dust because there is no further treatment, so the discharge of dust will seriously pollute the sandblasting room and the surrounding environment, the health of the site staff will also harm.
Post time: 13-02-23- Cold galvanized wire has good toughness and elasticity, high zinc content can reach 300 g/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. Cold galvanized wire is widely used in construction, handicrafts, wire mesh preparation, the production of galvanized hook mesh, wall mesh, highway guardrail, product packaging and daily civilian and other fields.
Post time: 27-09-22