Corrosion resistance: Molded grating should be the product of choice for severe corrosive environments. The one-piece fabrication and complete resin coverage adds to the natural chemical resistance of the materials used in our molded fiberglass grating. You also get excellent resistance to moisture, humidity, and bacterial growth for food and medical-related facilities.
However, it's important to note that carbon steel bits have their limitations
carbon steel drill bits. They heat up quickly during use, requiring frequent cooling with lubricants or water to prevent overheating and damage. They also tend to wear out faster than their HSS or carbide counterparts, especially when drilling through abrasive materials.
recreation
However, it's important to note that carbon steel bits have their limitations
- The smaller the mesh of decorative hook mesh, the finer the demand wire, the larger the mesh, the thicker the demand wire. For example, 6.5cm mesh aperture, the required iron diameter is 3.5mm-4mm. Then a fine welding will be broken, and then thick and heavy, workers can not bear.
Galvanized hexagonal mesh uses: building wall fixed, heat preservation, heat insulation; Power plant piping, boiler heating; Anti-freezing, residential protection, landscaping protection; Raise chicken and duck, isolate chicken and duck house, play the role of protecting poultry; Protect and support seawalls, hillsides, roads and Bridges and other waterworks.
Large roll of galvanized wire alloy elements in iron ore, can make copper through the material thickening degree of strengthening, hardness, impact force, strength resistance, closing rate, elongation, so alloy iron in the exercise of good iron, is an important supplementary element. The difference between galvanized wire and general iron wire is very big, general iron wire is cheap, and because iron is not very stable, easy to rust in wet places, so the stability is not very good, life is not very long.
The anticorrosion of these raw materials is very different, and the use of life is not the same. Niu LAN net cold galvanized, also known as electroplating, galvanized quantity is very little, rust in rain, but the price is cheap, the use of life in 5-6 years. Hot dip galvanizing (low zinc and high zinc) on the amount of zinc in 60 grams to 400 grams, the service life is about 20-60 years, corrosion resistance is general.
Post time: 28-04-22
Post time: 27-02-23
Post time: 13-06-24- In order to ensure the electrical conductivity of steel wire, manufacturers need to follow a number of standards and regulations. For example, in the galvanizing treatment of steel wire, the international standard ISO 1461 should be followed to ensure uniform zinc layer thickness and surface gloss. In wire drawing processing, excessive stretching should be avoided so as not to deform the wire or lose its mechanical properties.
Magnetic test method is the original common difference between austenitic stainless steel and ferritic stainless steel simple way, austenitic stainless steel is wrong magnetic steel, but after cold processing under large pressure will have a slight magnetic; But pure chrome steel and low alloy steel are strong magnetic steel.
Abandoned barbed wire guardrail network will generally choose classification pick up, classification gathering pick up and other methods, better to promote the better use of the whole highway guardrail network, abandoned metal guardrail network is still common copper mesh profile.
Post time: 16-05-23Electric galvanized shaft wire direct selling is in the plating tank through the current unidirectional zinc gradually plated on the metal appearance, the production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust. Compared with hot dip galvanizing, the production cost of electric galvanizing is lower. The difference between cold galvanizing and hot galvanizing: the difference between cold galvanizing and hot galvanizing is that the amount of zinc is different. They can be identified from the color. The color of cold galvanizing is shiny silver white with yellow. Hot dip galvanizing shiny white.
- Of course, the quality of any kind of product is also affected by the implementation of the specification of the manufacturer, if it is the welding screen manufacturers in the production of their own is not very high implementation of the specification, or in the production line of the procedure specification has declined, or there is no higher requirements on the production link.
B. When the thickness of the plating is greater than 4 mm, the zinc adhesion should not be less than 610g/m, that is, the average thickness of the zinc layer should not be less than 86 microns.
- If the requirements are higher, and it is humid place, it is recommended to use hot-dip galvanized barbed rope, although the price is higher, but the service life is longer, generally speaking, it is more cost-effective.
In the calculation process of 12*14 specifications of barbed rope, it can not be calculated according to the above calculation formula, because first of all, two specifications of raw materials are used, the thinner the wire diameter, the higher the processing cost. Generally speaking, a kilogram of 12*14 barbed rope can reach about 7.5 meters, and the ratio of warp wire to barbed rope cannot be calculated according to the traditional ratio of 7 to 3. The specific use of how much wire and silk need to go through a series of professional measurement but also increase the loss of raw materials and other factors to calculate. Thorn rope factory will also according to customer needs to calculate the reasonable amount of customer use.
Post time: 19-04-23- One is to do a good job of galvanized wire packaging, avoid bump, to ensure the integrity of the zinc layer;
- In order to figure out how many meters per kilogram of barbed rope, you also need to find out what type of barbed rope is, because different models will directly affect its weight.
Cold galvanizing is in the plating tank through the current unidirectional zinc gradually plated on the metal appearance, the production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, smooth, high aesthetics, poor corrosion resistance, generally a few months will rust. Hot dip galvanized coating is thicker, generally 30-60 microns, coating corrosion resistance is higher. Suitable for outdoor work of steel parts, such as highway fences, power towers, large size fasteners and other more “rough” workpiece long-term rust prevention.
Post time: 18-08-22- Stainless steel wire drawing is a metal processing (stainless steel) process, is a popular surface treatment technology in stainless steel and aluminum products industry today. It is a wire drawing effect treatment for stainless steel and aluminum products. So galvanized wire and stainless steel wire are two different products. In order to remove the surface film and surface inclusions on the surface of the deposited layer, the defects can be found and treated by conventional techniques. Excess foam is caused by soap and surfactant saponable fats brought into the tank.
With a large pickpocket used for steel wire, into the zinc liquid before the surface of the zinc ash stirring; Use a small outlet for galvanized steel wire; Zinc pot steel wire outlet in 30 minutes, with pickpockets back and forth, until the large, floating zinc residue into brown, real zinc ash, zinc ash surface. The extracted zinc ash should be brown yellow real zinc ash, zinc surface, effectively reduce zinc consumption. This is one of the biggest steps to bring zinc consumption down, and it’s a real problem, one that hasn’t been solved for years.
Steel mesh factory – improve the quality of reinforcement works. Electric welding wire mesh is produced by automatic intelligent production line under strict quality control in the factory. Strict control of mesh size, reinforcement specifications and quality. The omission of manual binding net is avoided, and the binding part is firm.
- Black iron wire is mainly used in the construction industry, handicrafts, woven screen, product packaging, parks and daily life used to tie the wire. Hot dip galvanized wire is processed from low carbon steel wire rod, which is processed through drawing molding, pickling and rust removal, high temperature annealing, hot dip galvanized and cooling, etc. Hot dip galvanized wire quotation, market
- The purpose of checking on time is to find problems in time. Users should go to the inspection on time if they can not install the blade barbed rope and ignore it. Local rust should be removed in time and local deformation should be corrected in time, and the service life of the blade barbed rope should be extended.
Post time: 01-08-22