Fiberglass covers are made for tanks, cooling towers, silos, pulley protection, hoods, sewage pools and odor-control applications. The suitable form depends on the structure being enclosed and the conditions around it. Identify the equipment, opening and service environment before requesting a design.

Yes. Covers can be produced in customer-requested sizes and shapes. Configurations include round, rectangular, arch, flat and house-type forms. Large units can be manufactured in sections to make transportation and site handling easier. For a quotation, send the opening or structure dimensions, preferred shape and required quantity.

These covers are used in water and sewage treatment, chemical and petroleum facilities, food processing and pharmaceutical applications. They are also suited to outdoor exposure involving sunlight, snow and salt-laden coastal air. Provide the chemicals, temperature range and exposure conditions so the resin and structure can be considered for the installation.

Yes. A fiberglass product weighs about one-third to one-quarter as much as a steel product. Lower weight can simplify handling during installation. Dividing a large cover into smaller sections can also help when transport routes, lifting access or the installation area are restricted.

Fiberglass covers provide corrosion resistance, and different resins can be selected for different conditions. The outer surface is designed for harsh environmental exposure, including sunlight, snow and salt-laden air near coastlines. The buyer should identify the chemicals and weather conditions at the site when specifying the cover.

Fiberglass has low thermal conductivity, so a cover can meet common insulation requirements without an additional insulation structure. The final design depends on the service conditions and operating temperature. Include those conditions with the dimensional information for a project review.

Wind and seismic parameters can be included in the structural calculation, and finite element analysis can be used to optimize the design. Multi-section covers are preassembled in the workshop so the sections can be checked for matching before site installation. Send the site layout, support arrangement, design loads and access limits when requesting a large-cover design.